솔라 30/35mm 다용도 엔드 클램프

솔라 30/35mm 다용도 엔드 클램프 is a handy thing for attaching solar panels to mounting rails, especially the ones on the edges. It works with both 30mm and 35mm thick panels, so it's good for different types of solar setups.

상표:

SIC SOLAR

품목 번호:

SIC-EC-C3035

Roof or Ground

구성 요소 기술 세부 사항 설치 가이드 패키지 Advantage FAQ

클램프에 대해 더 자세히 알아보려면 여기를 클릭하세요.

Solar Panel End Clamps

설치 현장	Roof or Ground
Wind Load	<60M/S
Snow Load	<1.4KN/M2
Material	Aluminum 6005-T5
Color	Natural or Customized
Anticorrosive	Anodized aluminum
Warranty	10 years and 25 years service time

1️⃣ 올바른 크기 선택: 패널 프레임의 두께(30mm 또는 35mm)를 확인하고, 그에 맞는 고정 장치 삽입물을 교체하세요.

2️⃣ Get It in Place: Put the end fixture on the panel's edge and line it up with the mounting rail.

3️⃣ Tighten It Down: Put the bolts into the rail nuts and tighten them to the right amount using a torque wrench.

4️⃣ Give It a Look: Make sure the fixture is flat against the panel frame and that all the fixtures are tightened evenly.

Easy Installation Aluminum Solar Panel End Clamp

Solar panel hold down clamps

☆ 고객의 요구에 따라 다양한 종류의 끝단 고정 장치를 제공할 수 있습니다.

☆ Really Tough Stuff – Made with the best AL6005-T5, so it’s guaranteed for 10 years and should last for 25.

☆ Smart nut design – you can slide the Tilt-in-module into any spot on the rail.

Solar rail installation

Related certificate

☆ Aluminum quality certificate -- AL6005-T5 composition list.

Q1. 볼트도 검은색으로 만들 수 있나요?

Yes.

Q2. Can the clamps be customized ?

Yes.